Metric Size Socket Set Screws
Thread Size: M1.4-M52
DIN913, DIN914, DIN915, DIN916
ISO4026, ISO4027, ISO4028, ISO4029
Various Drive and Point Types
Various Surface Finishes
Other Material Grades are available
Please feel free to contact us for more details
Here is how to install or refit the seat bolts on a Harley Davidson so you can get back behind the bars and into top gear and down the road. In this video we use a Harley Davidson Fatboy, but the procedure can be transferred to other models in the H-D range including Heritage, Deluxe, Softail, Fatbob, Low-Rider, Sporters as well as most touring models.
The Softail Manual reads:
The pillion seat attaches with a single screw at the rear and engages to the drivers’ seat mounting screw at the front.
To remove seat, first remove passenger seat buy unscrewing the rear retaining screwing and sliding the seat towards the rear of the bike to remove the locating slots from the front seat mounting fasteners. Next remove the front seat mounting fasteners and slide the seat rearwards to free the tang at the front of the seat. When installing the seat, insert the tang at front of seat into the channel in the frame and install seat-mounting nuts. Install passenger seat.
An Important Note: After installing seat, pull upward on seat to be sure it is locked in position. While riding, a loose seat can shift causing loss of control, which could result in death or serious injury.
The rear-retaining nut is held in position with a sliding retention washer.
If the retention washer is removed, the retention nut will fall through the fender. The procedure below is used to lift the retention nut up through the fender and back in position, with either a piece of wire or on a cable tie for ease of replacement.
Slide retention nut over the tapered end of a cable tie so that the larger O.D. of nut rests on the cable tie strap eyelet or if using a piece of wire bend the bottom end of the wire to prevent the nut from falling off.
Feed the cable tie or wire up through fender hole.
Ensure the tab on the retention nut is located in the notched hole on the fender. When the nut is snug against the underside of the rear fender slide the retention washer on the nut from the opposite side the of the nut’s locking tab.
For more information visit www.gonetouring.com.au
The rear door of my rental Manufactured home was leaking and I was not notified. Had to change out the door and replace part of the sill and floor. I went with a combination door this time.
UPDATE: On 3-11-2016 due to torrential rains in the neighborhood of 15″ in 5 hours, this manufactured home suffered flood waters and was declared a total loss by the insurance company. The home was raised almost 4 foot above the flood stage marked by the survey company and it still got a foot of water inside the home.