Using Ruskin’s FAST mounting angle can cut the time it takes to install your next fire or fire/smoke damper in half — and time is money.
The FAST Angle is fastened directly to the stud, before the fire rated gypsum wallboard is installed in this version of the installation.
There is also another video in the series that shows installation after the application of sheet rock: https://youtu.be/iCNHhVmP2HQ
UL Proven
The Ruskin FAST Angle is UL tested and approved for use in metal stud.
This is one more advanced solution and “Labor Saver” from the industry’s most knowledgeable air control professionals.
Contact Ruskin or your local Ruskin representative to see how you can take the FAST approach to fire and fire/smoke damper installations.
For more information: https://www.ruskin.com/file/doc/1689
*Audio licensed from Melodality for the Licensee: Johnson Controls (I) Pvt Ltd
The Quietness of Continuous Sweep Movements is delightful.
Looking for a Quiet Running Clock? Go To: https://www.clockparts.com/
Welcome to our continuous sweet clock movements. This is page an excellent sweep clock motor for your clock repair or to build a new
large clock.
A couple key points I want to go over to make sure it’s the right selection for you. There are two measurements when you’re doing clock repair or when you’re building a new clock. One is how long are your clock hands and another one is how long is the hand shaft.
When we look at measuring the length of your clock hands, we are not concerned with the hour hand. We’re only concerned with the longer one, the minute hand and we measure from the mounting hole to the
tip, no matter what size the hands are.
We’re not concerned with the part after; behind the mounting hole, the tail part of the clock hand. So in this case this clock hand is under five inches. We can use a mini quartz motor. We don’t have to use a high torque motor.
The mini quartz motor will drive hands up to five inches. Now when you purchase one of our continuous sweet mini quartz motor you’re gonna receive free clock hands.
The reason we do it is your old hands probably will not work with your new motor is every manufacturer makes their motors to their specifications and there’s no cross reference from one manufacturer to the other.
So when you’re buying one of your mini quartz motors just please ,you will be prompted during checkout to get a free set of hands. Just select those free set of hands. You’ll be glad you did. You can also purchase sweep second hands at; https://www.clockparts.com/sweep-second-hand/
Now with each motor you’re gonna get a pack of hardware. In that hardware is one a rubber washer, two a brass washer, three a hex nut ,a minute hand nut and five a cap nut.
So if it’s longer than the material you could you could if you wanted when you’re putting it on put that rubber washer and I could put a couple washers on it to shim it back.
View More ClockParts Videos: