For all your trade and DIY tools and materials visit – https://www.tradessupermarket.com
For DIY videos, expert advice and a great shop all in one visit – https://www.tradessupermarket.com/secrets
The basic error people make when using screws and raw plugs is that they use a drill bit that is too big for the plug or the wrong combination of tools and materials. Here we give you a little bit of advice on drilling and fixing.
In this video, OnlineEEI shows you step-by-step instructions on how to set up a portable pipe and drape backdrop kit using its 8 foot tall freestanding kit.
For more information, please visit our event decorating products international store:
https://www.onlineeei.com/
Here are the written, step-by-step instructions:
1. Remove screw from bottom of pin.
2. Push screw from bottom side through hole in center of base plate.
3. Tighten pin clockwise back onto screw with base plate in between. Repeat with second base plate and place them required width apart.
4. Slide (unslotted) bottom half of upright onto pin. Join upper half of upright post (piece with slots at top) with the unslotted bottom piece. Repeat with second upright.
5.The adjustable drape support rod is made up of 3 pieces: Two end pieces (each have a hook) and a middle piece (with 4 button holes). One of the end pieces is stored inside the middle piece. Pull this towards the hook side until the last button engages.
6. Snap the other end piece into the other end of the middle piece. The width is adjustable by disengaging these buttons.
7. Thread drapes onto adjustable drape support rod.
8. Place hook on one end of drape support rod snugly into upright slot.
9. Repeat with other end of drape support rod on second upright.
There are many creative uses for Pipe and Drape such as backdrops, room dividers, traffic control, or decorating. Use them at your next event!
Visit us on Facebook at https://www.facebook.com/onlineeei