Renewable Design for ASTM A320 L7 Combination Studs Combo Studs to Gabon Manufacturers
Renewable Design for ASTM A320 L7 Combination Studs Combo Studs to Gabon Manufacturers Related Video:
Building a T-Slot spoil board out of MDF for your CNC machine can be done quite easily in an evening and requires very little in the way of special bits/material. Best of all you will have no more worries about ruining your nice aluminum t-slot table!
Project information:
Material
3/4″ MDF
340mm x 525mm (W x L)
Bits:
6mm 2-flute endmill – https://amzn.to/1NDss5h
1/4″ T-Slot Bit – https://amzn.to/1NDsgml
5/8″ Straight Bit – https://amzn.to/1PBmvTO
Toolpath Feeds and Speeds:
Holes/Pocketing – 6mm End Mill: 12000 RPM, 2400mm/min
Slots (Bulk Removal) – 6mm End Mill: 12000 RPM, 2400mm/min
Slots (T-Slot Bit) – 1/4″ T-Slot Bit: 18000 RPM, 600mm/min
Surface Leveling – 5/8″ Straight Bit: 18000 RPM, 2000mm/min
Notes:
I subtracted 30mm off of the total length to allow the T-Slot bit room to completely enter/exit the spoilboard from the side of the material.
Watch out for the tops of the pan head screws when carving your T-slots! I had to adjust my Z depth so I would not hit them (I still ‘shaved’ the tops on a few of them 
)
The table leveling is a pass over the complete spoilboard at 0.2mm depth.
QUICK TIPS® Heel Cap & Wrap instantly fix worn heel tips without tools. Extra-strong rubber heel caps attach over worn heel tips using a self-fusing wrap. Wrap ensures a secure, long-lasting repair.
► Buy at https://GoGoHeel.com
► Available in 3 sizes and 2 colors (black, taupe)
► Perfect for quick fixes, in-between shoe repairs, and those that don’t live near a shoe repair shop
Video Demos:
► Apply: https://youtu.be/HzNoIUHTjzI
► Remove: https://youtu.be/kiU8w_6TF8M
—-
Video produced by Bryant Hwang