fischer FAZ-II anchor bolt for push through installation. When the hexagonal nut is tightened, the tapered bolt is pulled into the expansion clip and expands it against the drill hole wall.
In today’s video I take a look at the Coil Master Genesis RDTA which was sent in by Coil Master for showing you.
This is their first RDTA and I must say I think it’s a real belter of a tank. With a 6ml capacity. It comes with a spare glass tank, bag of washers and o-rings, grub screws, pack of cotton and the allen key.
Priced at around £23 in the UK I think it’s pretty good value considering the quality of it. Wicking can be a little tricky because you have to get the cotton down the holes in to the tank. I only did short wicks that just went in to the chamber so wetting the wicks has to be done by tilting or tipping the tank upside down for a few secs. You could also make longer wicks to trail right in to the juice if you prefer.
You can of course just drip on the wicks through the wide bore drip tip if you prefer.
I used both stock coils that came with it which turned out to be .34ohms each x 2 = .17ohms when firing. It produced huge clouds of thick, dense vapour as can be seen by the speed of it sinking back to ground!
Many thanks to Coil Master for sending this in to look at
https://www.coil-master.net
NEW FACEBOOK GROUP
https://www.facebook.com/groups/juicecabin/
COMPETITIONS EVERY WEEK
EQUIPMENT USED TO MAKE THE VIDEO
Main Camera: Canon XA35
Closeup Camera: Canon XA30
Microphone: Blue Yeti Pro via XLR
Streaming Device: Elgato HD60S
Streaming device 2: Live Gamer Extreme
Other Devices: Elgato Stream Deck
OBS Software