ASTM F912 F912M Alloy Steel Socket Set Screws Grub Screws
Metric Size: M1.4 – M52, Inch Size: 0# - 2"
Hexagon Socket(Allen), Torx Star, Square, Slotted Drive Types
Flat Point, Cup Point, Cone Point, Dog Point
Other Drive and Point Type are also available acc. to customer requirement
Various Surface Finishes
Various Material Grades are available
Please feel free to contact us for more details
Collapsible or Non-Collapsible. No nonsense quick video on how to install both a collapsible buffer tube and non-collapsible buttstock / buffer tube.
Note: Be sure you are installing the correct buffer spring for your application.
Collapsible procedure starts at 00:17.
1. Insert rear takedown detent pin if not already done. Insert rear takedown detent spring.
2. Thread collapsible buffer tube onto lower receiver until it gets close to the buffer retainer hole.
3. Insert buffer retainer spring and then insert buffer retainer.
4. Push down on buffer retainer with finger and finish threading on the buffer tube. Go just past the point that will keep the retainer down on it’s own.
5. Push end plate / sling adapter up against the back of the lower receiver. Be sure the spring stays straight.
6. Keep pressure on the end plate and then tighten up the castle nut as much as you can by hand. Then finish tightening with armorer’s wrench.
7. Insert buffer and buffer spring into buffer tube.
Non-Collapsible procedure starts at 02:37.
1. Thread non-collapsible buffer tube onto lower receiver until it gets close to the buffer retainer hole.
2. Insert buffer retainer spring and then insert buffer retainer.
3. Push down on buffer retainer with finger and finish threading on the buffer tube.
4. Insert rear takedown detent pin if not already done. Insert rear takedown detent spring.
5. Slide buttstock onto buffer tube. Be sure spring stays straight.
6. Fasten buttstock to buffer tube with screw.
7. Insert buffer and buffer spring into buffer tube.