Standard OD Socket Set – 3/4″ to 3 1/4″ (4″ deep)
Big OD & ID Cleaner Set – 4″ to 6″ (8″ deep)
Bolt Cleaning Machine (OD) – 3/4″ to 3″ Any Length w/ Dust Collection
Big Brother Bolt Cleaner (OD) – 3″ to 7″ up to 14′ in length w/ Dust Collection
Individual, close tolerance and custom sizes available as well.
For more information, visit us at:
https://www.hesseco.com/boltcleaners.html
Watch more Bathroom Repair videos: https://www.howcast.com/videos/394212-How-to-Fix-a-Toilet-Flange
If your toilet wobbles, has a leak, or if you smell sewer gas in your bathroom, you may have a broken flange.
Step 1: Remove old flange
Remove the old flange by breaking it away from the drainpipe, or closet bend, with a small sledgehammer and a cold chisel. The flange is made of cast iron, so it will break away fairly easily. Once it’s broken, pry it up and out with a pry bar.
Tip
Be careful not to damage the closet bend when you’re removing the flange.
Step 2: Fit new flange over closet bend
Set the new flange over the closet bend and mark any spots on the floor where it doesn’t lay flush. Remove the new flange and use the hammer and chisel again to break away the parts of the floor you marked. If the flange doesn’t sit flush with the floor, the toilet will wobble.
Step 3: Install rubber gasket and brass ring
Fit the rubber gasket between the inside of the flange and the closet bend, tapered edge down. Then fit the brass ring over the rubber gasket, tapping it into place with the hammer.
Step 4: Tighten the flange
Use the socket wrench to tighten the bolts connecting the brass ring to the flange and securing it to the floor.
Tip
Tighten the bolts a little bit at a time to evenly force the rubber gasket downward.
Step 5: Insert closet bolts and wax ring
Insert closet bolts into the slots on either side of the flange. Then press a new wax ring over the flange to prevent water and sewer gas from leaking out.
Step 6: Replace the toilet
Set the toilet on top of the flange, making sure the closet bolts line up with and come through the holes in the base of the toilet. Put a white plastic base, a brass washer, and a hex nut onto each bolt, tightening the nuts with your socket wrench.
Step 7: Attach plastic bolt covers
Snap the plastic covers over the exposed closet bolts, reconnect the water supply, and flush the toilet to inspect it for leaks. Try to wiggle the toilet. If it wobbles, carefully tighten the closet bolts a little more. After making sure the toilet is sturdy, you’ll be able to sit securely without worrying about leaks or sewer gas.
Did You Know?
Toilet paper on a roll wasn’t introduced until 1880.