Progress is coming along now on the Golden Arrow. I started out with three of them and planned to make two but discovered that I have only one usable chassis. I made a custom rear suspension shaft out of an m5x140mm long (5mm diameter) hex screw. The same will be done for the front suspension shaft as well. I also used m3 (3mm) hex screws and nylon insert locknuts to secure the round metal plates that attach to the differential spur gear so now the Golden Arrow can be disassembled much easier for servicing. I decided to utilize my trinity epic 27 turn stock motor (brushed, ball bearing) as the motor case is black and matches the Golden Arrow quite nicely. The gearbox is now rebuilt with all ball bearings and new axle shafts (traxxas #1246) were also installed. I will be using an hpi sc-15 esc. And, a hitec mighty mini servo for the steering. Titanium turnbuckles are planned. As always, progress has been somewhat slow but now it is finally starting to come along. I welcome questions, comments, and any suggestions. Thanks for watching.
Fidelity Express Agent How-To
For additional assistance, call us at 800-621-8030.
Step-by-Step Transcript
Insert your key into the printer lock, unlock the lid, lift it away and remove it, set it aside.
Look at the inner-workings of the printer.
On the bottom right-hand side, just to the right of the printer ribbon, there’s a silver metal bracket. That metal bracket is bent at a 90 degree angle and is located approximately two inches from the bottom right-hand corner of the printer. There are some wires that go to that metal bracket. They’re in place with set screws.
Place your right index finger behind and below that silver metal bracket and lift straight up.
This will activate a switch in the printer and you’ll see the money order advance forward.
Hold that switch in place.
With your left hand, press the ‘Load’ button at the same time.
This will eject your form from a Certex printer.