Nylon Tip Socket Set Screws
Metric Size: M1.4-M52, Inch Size: 0# - 2"
Various Drive and Point Types
Various Surface Finishes
Other Material Grades are available
Please feel free to contact us for more details
Eccentric Lock Washer™ Comparison test:Anti loosening performance
95-05 Cavalier, Malibu, Corsica, Sunfire, Nubira, Lanos, Grand Am, Alero, Cutlass, and Saturn
((Note: Models listed above CAN have the same transmission.))
IF YOU HAVE A DIFFERENT TRANSMISSION THE PARTS LISTED WILL NOT BE THE SAME ! ! ! !
IF YOU HAVE A DIFFERENT VEHICLE SOME OF THE PARTS LISTED MAY NOT BE THE SAME ! ! ! !
The current project is a (98 Cavalier). Depending on year and model torque specs and methods of installation may vary widely!
IT SHOULD BE NOTED! There are 3 basic ways to remove the CV axle. Depending on YOUR model vehicle some will work and SOME WILL NOT WORK ! :-/
1st way – Unbolt the strut from the steering knuckle as I did in this video and swing the hub and assembly down out of the way.
2nd way – Remove the brake caliper and hub assembly, then pull the CV axle through the same hole if its large enough to fit.
3rd way – Remove the tie rod and lower ball joint and swing the hub and strut outward to remove the CV axle. (nylon tie rod nut replacement required)
“The 4T40E is a four speed automatic transaxle designed and built by General Motors. It was first used in 1995 in the Chevrolet Cavalier and Corsica, along with the Pontiac Sunfire. The transmission was used up through 2005 in many other vehicles, including the Daewoo Nubira and Lanos, the Chevrolet Malibu, the Pontiac Grand Am, the Oldmobile Alero and Cutlass, and the Saturn L-Series of vehicles.”
(Details:) https://etereman.com/blog/general-motors-transmission/what-you-need-to-know-about-the-gm-4t40e-transmission
“HYDRA-MATIC 4T40-E Transaxle (RPO MN4) and 2.2L, 2.3L, 2.4L Engine (VINs 4, D, T – RPOs LN2, LD2, LD9)”
(Details:) https://www.justanswer.com/chevy/2q805-98-cavalier-remove-small-stub-inner-cv-joint.html
CV Axle Spindle Nut Torque Spec (1998 Chevrolet Cavalier) “144lbs”
All other models are listed on the following website below!
(Details:) https://www.speedwayautoparts.com/Torque%20Specs.pdf
Strut Shock Lower Bolts Torque “95lbs”
Passenger Side Parts Used:
CV Shaft Axle “NCV10585″ (www.advanceautoparts.com)
Oil Seal Kit “5693″ (www.advanceautoparts.com)
Output Stub Shaft “24200734″ (www.rockauto.com)
Removing Axle Nut (06:39)
Removing Brake Line Bracket and Lower Strut Bolts (10:26)
Pulling CV Axle from Hub Assembly (13:09)
Removing CV from Transaxle (14:08)
Removing Stub Shaft from CV Axle (21:33)
Installing Stub Shaft Seal Sleeve (24:32)
Removing Transaxle Seal (35:04)
Best example i could find for removing seal faster if your stub shaft doesn’t have a seal sleeve in the way.