Removing front bearing of 2008 Hyundai Santa Fe GLS 2WD 2.7L
The entire process to remove and install took about 2 hours total. I tried to cut this video down to 10 minutes for the removal portion. I posted this because I read that this job required special tools, you had to remove numerous parts including the knuckle off the car, and only a professional should attempt this because it is too complicated. None of that was true. There are just two tricky parts where you have to move a couple of bolts or nuts out of the way and/or rotate the steering wheel to get better access to bolts. It is otherwise pretty straightforward. I admit this video is poorly shot and edited, but it should be enough for someone with a little mechanical experience to figure out what to do. I hope it helps someone.
Some tips on the proper way to install a aluminum fuel tank in boat. Which does not include foam or fiberglass. Only Neoprene rubber, 5200 , screws, and thats it. Dont use anything that holds water like WOOD or FOAM it will cause crevice corrosion.