Radio Flyer Customer Service demonstrates how to remove hub caps from Radio Flyer toys. Please contact our Customer Service Team for additional assistance: https://bit.ly/rfcustomerservice
Time lapse of 3D printed “BIG Nut And Bolt”. Time lapse taken from my Octoprint server attached to my Printrbot Simple Makers 1405 using the standard Raspberry Pi camera and a wide angle clip on lens.
A very cool print to make and great to show off to people. Very satisfying to spin the nut on and off! Had to screw it on and off a couple of times to loosen up the thread so it was smooth – could also put some silicone sealant on it to make it even more smooth, but it doesn’t need it.
Scaled it down to about 60% for it to fit into my printer upright. Would love to print this full size or bigger as a great novelty item and showcase as to what can be 3D printed.
An oddity of the design from an engineers point of view if this was a functional piece is that the nut has a different size hex to the bolt head, so you would need two different spanners to fasten this nut and bolt, or a pair of adjustable one?!
Original model is by be3D_printers and can be found here – https://www.thingiverse.com/thing:387266.
My make can be found here – https://www.thingiverse.com/make:222068
Print Settings Below:
Filament: Printed using 3D Prima 1.75 PLA – Dark Grey
Filament used: 10.844m 32.0g
Layer Height: 0.2064mm
Temperature: 210°C
Perimeters: 2 at 0.4mm (0.8mm total)
Infill: 25%
Raft: No
Brim: No
Support: None
Speed: 20mm/s
Time: About 4 hour
Scale: 60%
Still trying to get a better set up for my time lapses. Think the built in Raspberry Pi camera is not suited and I may have to set up an external camera – comment below if you have any tips or suggestions?!
Any questions or queries please feel free to comment. Please subscribe for more 3D printing videos.