Purchase Adjustment Screw: https://www.Taylor-Tactical-Supply.com
Add me to your Google+ Circles:https://plus.google.com/+nictaylor00/posts
Please join me on Facebook for additional pictures:
FaceBook – https://www.facebook.com/NicTaylor00
Twitter – https://twitter.com/nictaylor00
INSTRUCTIONS:
1. The internal set screw comes with thread locker pre-applied but for best results remove the internal screw and apply additional thread locker and re install the set screw inside the
large screw. Make sure to screw down the internal screw all the way in so that the tip just protrudes.
2. Remove the factory grip screw and lock washer from the grip of your rifle. Mind the spring and detent for the safety as they may bounce out if you remove the grip completely.
3. With the hammer cocked and the gun on safe, insert the Trigger Adjustment Screw into the grip and tighten the large screw with a 3/16” hex wrench until he pistol grip is secure.
4. Using the included hex wrench, finger tighten the internal screw inside the 3/16” screw until the it stops. DO NOT OVER TIGHTEN. Backout the internal screw 1/4 turn at a time
until the safety lever can by actuated. Verify that the trigger, disconnector, hammer and safety function correctly. Let your additional thread locker dry before putting your rifle to use.
Music by TeknoAXE, “Cover Blown” https://youtu.be/Kjai-kvSvH4
A combination of material aging and the lack of maintenance by the owners resulted on the deterioration of the support beams and all the materials used over them. Take these sample and work on your project with caution. I hope I was able to answer some of your concerns.