General Pump sandblasting kit test run on the wheel of my M35A2 deuce and a half.
SKU# 88.0036 at PWMall site. This is a great product. I ran out of sand and time but there will be a follow up video this spring of the blasting of the whole truck.
Abrasive used was Home Depot masons sand. Dried, screened, and bagged for about $3/50lbs.
Here I have demonstrated how to remove the three bolt flanges off the end of headers and install our Marman flanges. The reason why we do this is because with the 3 bolt flanges you can’t seem to get them to stop leaking. Plus the bolts do back out causing a blow out of the gasket by using our Marman flanges, you will no longer have any leaks. If you count the parts that are required for a 3 bolt flange connection including the flanges the gaskets and all the nuts and bolts there’s 27 pieces. When you use our Marman flange assembly, there is only 4. The male and the female ends the gasket and the clamp. Why not go V-band? Because they leak as well. These have a 1000lb burst pressure on them without leaks. V-bands have a 3-4% leak at ANY pressure.