If you start to notice your FWD vehicle clicking when you make a tight turn, you might have an issue with the outer CV joint. If you make a right turn, it’s usually the left side that’s bad and vice versa. Most axles are easy to replace and the one depicted in this video is fairly typical of what you run into. The main differences come in with how the lower ball joint is attached. I think this part will give you the most trouble. I often get asked about what to torque the axle nut to. To be hones, I don’t know. I’ve only ever run them down with my impact. I’ve never had an issue doing it that way and I don’t think you would either. Just be sure to stake the nut or install the cotter pin and retaining clip if it has one. If you’d like more information on how to deal with suspension noises, check out this article I wrote on the topic.
https://www.ericthecarguy.com/faq/diagnosing-noises-in-your-car
Video on CV boot replacement: https://www.youtube.com/watch?v=-S-ofMoWsr0
The best place for answers to your automotive questions: https://www.ericthecarguy.com
Facebook: https://www.facebook.com/EricTheCarGuy?fref=ts
Twitter: https://twitter.com/EricTheCarGuy
Google+: https://plus.google.com/100195180196698058780/posts
Information on Premium Membership: https://www.ericthecarguy.com/premium-content-streaming-etcg-content
Stay Dirty
ETCG
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.
Cutting an external thread – (N.B. Die inverted in stock to give clearer view of thread as it is cut ) – Buggy task – Axles – Design & Technology On The Web – www.design-technology.info