ASME B18.3 Socket Set Screws
Imperial Thread Size: 0# - 2"
Various Drive and Point Types
Various Surface Finishes
Other Material Grades are available
Please feel free to contact us for more details
allen bolt
allen bolt types
allen bolt
gear shift assembly
lock nut tightening
locknut tool removal
locknut technology
locknut tyre
locknut type
locknut tightening tool
locknut tightening procedure
locknut tightening dolley
remove the gearshift lever assembly dowel bolt
remove the remaining bolts
remove the gear shaft assembly
remove shift block actuator allen bolt
remove rear housing bolt front housing side
remove flange bolts from reverse idler shaft
outshaft locknut
remove the locknut
dolly-counter shaft top gearing
using mallet , gently tap the MST and install the DGB bearing
dolly-counter shaft bottom and middle bearing
dolly-3rd gear hub pressing
using hydraulic press, fit the synchro pack
locking wheel bolts
1 2 nylock nut
lock nut tool
2 inch lock nut
lock wheel nuts
m5 lock nut
sealing lock nut
slewing ring bearing
track roller bearing
cheap ball bearings
conveyor bearings
small ball bearings for sale
deep groove radial ball bearings
In this video I take a look at the Augvape MTL RTA sent in by Augvape for looking at.
It’s a small tank with a capacity of 3ml made from stainless (mine is black), comes with spare glass tank, allan key, bag of washers, grub screws, stainless MTL drip tip, wide bore drip tip, a single coil and some air flow control plugs.
I found it way too fiddly to use with the air flow control ring not attached to the main tank so it comes off easy, the washers then get caught in the ring dead easy. The top filling mechanism is also fiddly to use because there’s almost nothing to hold on to in order to unscrew the top cap meaning the tank starts to come apart again.
It’s got an awful lot of air flow control options including the ‘normal’ air flow control ring but it also has 4 additional plugs that screw in the centre air hole which effectively narrows it making the draw tighter, you then also have 4 tiny grub screws that are in the post and this too allows additional air in the system – that’s three different combinations of air flow control which for me is way overkill.
It gave a good tight draw for MTL on the single coil and air flow control turned fully closed. It can be used for direct to lung with the default air hole (3.5mm) and the air flow ring fully open.
Flavour was good though but priced at around £27 in the UK I reckon it’s a little pricey.
FULL SPECS
22MM DIAMETER
22 X 43MM WITH 510 DRIP TIP
22 X 54MM WITH MTL DRIP TIP
3ML CAPACITY
304 STAINLESS STEEL CONSTRUCTION
DUAL BLOCK POST DECK DESIGN
THREADED TOP FILL
CHANGEABLE AIRFLOW PLUG DIAMETERS (1.2MM, 1.6MM, 2MM, 2.5MM, 3.5MM)
SIDE AIRFLOW GRUB SCREW ADJUSTMENT
BOTTOM AFC RING
STAINLESS STEEL MTL OR WIDE BORE 510 DRIP TIP OPTIONS
Thanks to Augvape for sending in the Merlin MTL RTA
https://www.augvape.com
NEW FACEBOOK GROUP
https://www.facebook.com/groups/juicecabin/
COMPETITIONS EVERY WEEK
EQUIPMENT USED TO MAKE THE VIDEO
Main Camera: Canon XA35
Closeup Camera: Canon XA30
Microphone: Blue Yeti Pro via XLR
Streaming Device: Elgato HD60S
Streaming device 2: Live Gamer Extreme
Other Devices: Elgato Stream Deck
OBS Software