https://www.firealarmsonline.com brings you this new conduit bending video which explains how to properly bend a 90 degree bend or stub, along with a back to back 90, a conduit offset with shrinkage and a three bend saddle. All of these bends are easily done with a conduit hand bender and all of the shrinkage factors and measurements can be found on our website. Make sure to always subtract the necessary amount when bending a conduit stub. In this video I used 1/2″ EMT conduit so the subtraction amount is 5″ for a stub or 90 degree bend. Once you have the stub bent, it is very easy to make a back to back 90 by simply measuring the distance needed and using the star mark on the conduit hand bender. For an offset make sure to visit our website to get the necessary shrinkage factors and make your marks depending on what degree beds you want to use. For 45 degree offsets, the multiplier factor is 1.4. Three bend saddles are very easy. Just measure from your fixed starting point and add the necessary measurement for shrinkage. Add 3/16″ for every 1″ of offset depth. The two outer marks are determined by adding 2 1/2″ for every 1″ of offset depth. Make the middle bend 45 degrees at the notch on the bender and the two outer bends at 22 1/2 degree while making sure to keep the bender hook facing the middle bend at all times. Check out the video and let us know if you have any questions.