This animation was created using Autodesk Inventor software and shows the installation process for the unitized curtain wall I designed at the company where I work. Every component in the model was created from “scratch” including nuts and bolts, and more than 70 new custom extrusion profiles, to make this model. Each individual window unit contains more that 700 parts. The model contains over 6,000 parts. Curtain wall is the glass, aluminum, metal panel, and sometimes, stone facade used on medium and high rise buildings. Unitized curtain wall is a curtain wall that is engineered, manufactured, assembled, and glazed at a factory, and shipped to the project site for field installation. As shown in the video, the curtain wall is installed one panel at a time anchored to the structure. Each panel varies in size, but are typically around 5′-0″ wide and 11′-0″ to 14′-0″ in height.
In this video I show how to solve a Rubik’s Cube with a 7 step layer by layer beginner method, that will give you a good foundation for learning a speed method in the future. All cases are covered and timestamps and Algorithms are below!
Algorithms:
Step 3: To the Right: (U R U’ R’) (U’ F’ U F)
Step 3: To the Left: (U’ L’ U L) (U F U’ F’)
Step 4: Easy Algorithm: (F R U) (R’ U’ F’)
Step 5: Corner Twist: R’ U2 R U R’ U R
Step 6: Corner Swap: R’ F R’ B2 R F’ R’ B2 R2
Step 7: Edge Cycle: (R U’)(R U)(R U)(R U’) R’ U’ R2
Time stamps:
Step 1a: Prepare Cross 2:57
Case 1: Red facing you on side: 4:22
Case 2: Red facing down: 4:50
Case 3: Red facing you on top: 5:16
Case 4: Red facing you on bottom: 5:38
Step 1b: Finish Cross 6:14
Step 2: Corners 8:02
Case 1: Red facing you on left: 8:37
Case 2: Red facing up: 10:01
Case 3: Red facing you on right: 11:11
Case 4: Red in bottom layer: 11:52
Step 3: Middle Layer Edges: 12:56
Case 1: To the Right: 13:52
Case 2: No edge in top layer: 14:35
Case 3: To the Left: 15:45
Step 4: Orient Last Layer (LL) Edges 16:48
Case 1: Target 17:41
Case 2: No edges up: 17:58
Case 3: Two edges up adjacent: 18:17
Step 5: Orient Last Layer (LL) Corners: 19:00
Step 6: Permute LL Corners: 21:34
Case 1: Headlights 22:05
Case 2: No Headlights 22:44
Step 7: Permute LL Edges 23:44
Case 1: Target One edge done: 23:57
Case 2: Not Target 22:50
My facebook: https://facebook.com/redKB.FB
My twitter: https://twitter.com/KennethBrandon
My google+: https://google.com/+RedKB
My instagram: https://instagram.com/red.kb
Here’s the gear I’m using:
https://bit.ly/RedKB-Gear