Far responds to market increasing demands for more information on the use of the FHU05 and its heads and is pleased to put on line the explanatory video on how to assemble the heads for the pin&collars.
For technical features, please check our website: https://www.far.bo.it/en/products/riveting-tools-for-blind-rivets/pneumatic-hydropneumatic-tools/fhu-05.html
To find all our products:
https://far.bo.it/en/catalog/products.html
For more information about FAR, which since 1957 has been producing rivets, rivet nuts and high-technology riveting tools, visit the website:
https://www.far.bo.it/en/
Subscribe to the channel and continue to follow us:
https://www.youtube.com/channel/UCNqjWm7nDGNNP0nx12rPE_Q
I’ve always wanted a snow plow for my scx10 so i put one together out of spare parts i had laying around. i will start with the brackets that hold the entire thing to the truck its self that set up is a 3 racing lift kit for the scx10, the bars that hold the A-arm to the brackets are old broken shock bars from a rustler i had to trim them a little so they would fit the way they do, then the A-arm that reaches out is the rear A-arm from a 2wd traxxas slash, then the knuckle that is attached to the winch hook is from a rustler vxl. i am not sure what size the nut and bolt that will eventually hold the 3 inch diameter pvc pipe as the plow. The nuts on the end of the shock arms are 3mm. i am using electrical tape to keep the shock arms from sliding out. the only testing i have done is what you see in this vid.