Leah shows the quickest and cheapest way to sort and organize all those little nuts, bolts, screws, washers and doodads in your shop.
Support See Jane Drill by shopping on Amazon through our link: https://www.amazon.com/?tag=sejadr-20
Channel
https://www.youtube.com/seejanedrill
https://www.facebook.com/seejanedrill
Website
https://www.seejanedrill.com
https://www.twitter.com/seejanedrill
Disclaimer:
Due to factors beyond the control of See Jane Drill, we cannot guarantee against improper use or unauthorized modifications of this information. See Jane Drill assumes no liability for property damage or injury incurred as a result of any of the information contained in these videos. Use this information at your own risk. See Jane Drill recommends safe practices when working with tools seen or implied in our video and written content. Due to factors beyond the control of See Jane Drill, no information contained on this youtube channel, Facebook page, website and Twitter page shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this content is the sole responsibility of the user and not See Jane Drill.
I built this quadcopter from scratch using carbon fiber tubes and sheet for the body (from an Ebay seller in China,) 1000 kv brushless RTF Quads Red Special outrunners, 20 amp ESCs, a PDB and Multiwii Pro2 FC, as well as 9 x 4.5″ props all from RTF Quads down in Florida. It also utilizes a capacitive power conditioner from HK and it will be running a 2200mah li po also from HK. It is held together with 6-32 x 1″ stainless cap screws and matching stainless nylon insert ESNA locking nuts.