The head gasket on my 90 Civic DX has started to go bad. I was using an eBay head gasket set that I purchased for $40 for the complete kit. It gave me a solid year of running the car hard every chance I was given. I don’t think it helps that I didn’t have the head resurfaced when I first installed it onto this different block but I can’t complain. The head has been resurfaced and acid dipped and I’m just waiting for a Supertech head gasket and Supertech valve stem seals to arrive so I can re-install it.
I want to have this car ready at least a month before the season begins so I can work out any issues or areas that need fixing.
Help Support my channel, purchase decals here – https://garagebuilthondas.bigcartel.com
Send me stuff here!
Jon Widmer
PO Box 13594
El Paso, TX 79913
https://instagram.com/jon_widmer
Music – https://soundcloud.com/ninety9live/myrne-architect
Thanks for watching!
GameChanger– the new GRS-16 Guide Rail Square: 5-seconds to accurate!
This accessory is designed to make square cuts with Track Saws much faster and more reliably accurate than any other track square. – Guaranteed!
Until now, all the accessories for squaring up a track saw guide rail relied in some way on the loose-tolerance T-slot found on just about every track or guide rail.
To overcome the inherent inaccuracy of clamping to this T-slot you needed to use a separate reference square to align the track square before each use.
This meant you were dealing with as many as FIVE loose items to assemble and align before you can make an accurate cross-cut: 1 Squaring accessory; 1 „T“bar for inserting into T-slot; 2 hex head bolts ¼-20; 2 Knobs or wingnuts and 1 Precision reference square
5 items total !
GameChanger: GRS-16 Guide Rail Square
Completely self-contained and self-aligning
5-seconds to accurate:
* Slide it on the guide rail
* Lock the Draw Latch – DONE
Accurate cross cuts with a track saw: now a snap
The smooth, flat bottom means no-mar handling on workpieces. Ergonomic handle for lifting to reposition track clear of non-slip track pads.
* 5-second set-up entirely from above
* Unbeatable accuracy
* Very strong alignment connection
* No reference square required
* No re-checking needed in use
* Zero-clearance between Square and track edge visually confirms accuracy
* No loose parts
Technical
Dim. approx. 16 x 6 x 2 inches; Wt. approx. 2 lbs.
Precision CNC machined one-piece 6061-T6 Aluminum, anodized.
Over Center Draw Latch: 304 S.S. with compensating spring. Attached with SS 8-32 x .375” Screws 9/64” Allen.
Track edge supported by the Square to prevent deformation by Latch.
No reliance on Track T-slot for alignment accuracy.
Compatible with FESTOOL, Makita and TRITON tracks **.
** Not for BOSCH or DeWalt