Norman Kelly performing a G3 (vertical) weld on a 6 inch clip.
https://www.BadAceTactical.com
This is our new generation bent bolt – milled from a whole piece of stainless steel.
Three step installation:
1. Cut the ball
2. Thread the shank
3. Loctite the bolt handle and tighten set screws
Three major advantages comparing to other solutions:
1. The bolt handle is perfectly vertical to the bolt itself, so you don’t need to worry about the drilling angle.
2. The bolt handle shank is 10mm in diameter, which provides a stronger platform than the drill-and-tap method.
3. Because the M10 threading provides a much larger surface, once loctited, it is very solid and be able to handle the hardest recoil.