Soudage de goujons avec le Procédé SIG, Stud Inert Gaz EQUIPEMENT JUPITER 400I, Version INVERTER, et pistolet G20GNV pour souder des goujons en acier S235 M8 (ref: SGF XC…), Goujons symétriques.
1 mandrin (ref: MA080), 1 buse (ref: BRG3055150)
sur une tôle (acier S235, ep: 3mm) Normes : DIN EN ISO 13918, 898-1.
GameChanger– the new GRS-16 Guide Rail Square: 5-seconds to accurate!
This accessory is designed to make square cuts with Track Saws much faster and more reliably accurate than any other track square. – Guaranteed!
Until now, all the accessories for squaring up a track saw guide rail relied in some way on the loose-tolerance T-slot found on just about every track or guide rail. What we’ve done is so revolutionary it’s Patent Pending.
To overcome the inherent inaccuracy of clamping to this T-slot you needed to use a separate reference square to align the track square before each use.
This meant you were dealing with as many as FIVE loose items to assemble and align before you can make an accurate cross-cut: 1 Squaring accessory; 1 “T“bar for inserting into T-slot; 2 hex head bolts ¼-20; 2 Knobs or wingnuts and 1 Precision reference square. 5 items total! Not any more.
GameChanger: GRS-16 Guide Rail Square is compatible with FESTOOL, Makita and TRITON tracks **.
Completely self-contained and self-aligning
5-seconds to accurate:
* Slide it on the guide rail
* Lock the Draw Latch – You’re DONE!
Accurate cross cuts with a track saw: now a snap.
The smooth, flat bottom means no-mar handling on workpieces. Ergonomic handle for lifting to reposition track clear of non-slip track pads.
5-second set-up entirely from above
Unbeatable accuracy
Very strong alignment connection
No reference square required
No re-checking needed in use
Zero-clearance between Square and track edge visually confirms accuracy
No loose parts
Technical
Dim. approx. 16 x 6 x 2 inches; Wt. approx. 2 lbs.
Precision CNC machined one-piece 6061-T6 Aluminum, anodized.
Over Center Draw Latch: 304 S.S. with compensating spring. Attached with SS 8-32 x .375” Screws (9/64” Allen).
Track edge supported by the Square to prevent deformation by Latch.
No reliance on Track T-slot for alignment accuracy.
** (Not for BOSCH or DeWalt)
User feedback and suggestions always welcome!
The TSO Products GRS-16 is Patent Pending
Product specs and design subject change without notice as we continue to improve the product.
SYSTAINER is a Trademark of FESTOOL Tool Technic Tanos.
GRS-16 ™ TSO Products, LLC – All Rights Reserved © 2016