When you’ve got a bolt that has a rounded off head, it’s hard, and very frustrating, to try to get it loose. On this stuck bolt, I tried a socket, vice grip pliers and even a pipe wrench, but couldn’t get it off. Because the head was rounded off, and the position the bolt was in… well, I just couldn’t get a good enough bite on it to loosen it.
So… what to do?
Well here is a great… last resort way… for removing a stuck, rounded-off bolt… when all else fails.
Take care,
alan
homesteadadvisor.com
https://homesteadadvisor.com/store/
Here’s a link to the PB B’laster I highly recommend: https://astore.amazon.com/homegardenfarmimprovementemergencypreparedness.homesadvis0b-20/detail/B000I2079E
And here’s a 12 pack of the PB B’laster: https://astore.amazon.com/homegardenfarmimprovementemergencypreparedness.homesadvis0b-20/detail/B006Q7PH9A
Here’s the link to a Lincoln AC225 Welder (crackerbox) : https://astore.amazon.com/homegardenfarmimprovementemergencypreparedness.homesadvis0b-20/detail/B0000CBIKA
Here’s a link to an AC/DC Lincoln : https://astore.amazon.com/homegardenfarmimprovementemergencypreparedness.homesadvis0b-20/detail/B000GBORWK
Another B’laster Product : https://astore.amazon.com/homegardenfarmimprovementemergencypreparedness.homesadvis0b-20/detail/B0013JVYY8
• 120-200 Parts per Hour
• Hydraulic Drive of Forming Roll Forward/Reverse
• PLC Control with Touch Panel Operator Interface
• Rapid Part Cycle 2-4 Parts per Minute
• Vacuum Lift Material Feed Conveyor
• Pneumatic In-Feed Table with Material Squaring Arms
• Pneumatic Part Ejector
• Capacity Range up to 96 Inches in Forming Length
• Thickness Ranges .010 – .250 inch
• Designed to Operate 24/7