This video demonstrates how to easily pot metal and zinc die cast can be repaired at half the melting point of the parent metal.
Super Alloy 1 from https://www.muggyweld.com has a working temp of 350 degrees F, and bonds to the pot metal without distortion or warpage. Pot metal and zinc die cast had previously been considered impossible to repair in the welding, brazing and soldering field. Super Alloy 1 makes impossible repairs possible.
Please read all instructions prior to use at: https://www.muggyweld.com/wp-content/uploads/2017/04/Super-Alloy-1-instructions.pdf
For more videos and information, or to order, visit https://MuggyWeld.com
International customers, please order at: https://www.ebay.com/usr/muggyweld
_________________
Please visit https://www.aws.org/technical/facts/ prior to using Muggy Weld products, and adhere to all AWS welding safety guidelines. Further product safety information is available at https://muggyweld.com/safety-guidelines.
Muggy Weld LLC shall not be liable for any loss, injury, claim, liability, or damage of any kind resulting in any way from (a) your use of this Site, (b) any services or products obtained from this Site, (c) any errors in or omissions from this Site, (d) the unavailability or interruption of this Site or any features thereof, (e) any content contained on this Site.
MSDS sheets available with purchase from MuggyWeld.com, upon request.
If you start to notice your FWD vehicle clicking when you make a tight turn, you might have an issue with the outer CV joint. If you make a right turn, it’s usually the left side that’s bad and vice versa. Most axles are easy to replace and the one depicted in this video is fairly typical of what you run into. The main differences come in with how the lower ball joint is attached. I think this part will give you the most trouble. I often get asked about what to torque the axle nut to. To be hones, I don’t know. I’ve only ever run them down with my impact. I’ve never had an issue doing it that way and I don’t think you would either. Just be sure to stake the nut or install the cotter pin and retaining clip if it has one. If you’d like more information on how to deal with suspension noises, check out this article I wrote on the topic.
https://www.ericthecarguy.com/faq/diagnosing-noises-in-your-car
Video on CV boot replacement: https://www.youtube.com/watch?v=-S-ofMoWsr0
The best place for answers to your automotive questions: https://www.ericthecarguy.com
Facebook: https://www.facebook.com/EricTheCarGuy?fref=ts
Twitter: https://twitter.com/EricTheCarGuy
Google+: https://plus.google.com/100195180196698058780/posts
Information on Premium Membership: https://www.ericthecarguy.com/premium-content-streaming-etcg-content
Stay Dirty
ETCG
Due to factors beyond the control of EricTheCarGuy, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. EricTheCarGuy assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. EricTheCarGuy recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of EricTheCarGuy, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not EricTheCarGuy.