Automatic wire nails making machines – series THA
https://www.kovopol.cz/
country of origin: CZECH REPUBLIC
contact: pavlina.chlumska@kovopol.cz
Automatic nail making machines (series THA) are designed to manufacture nails and other products from steel, copper, brass and aluminum alloys wire of round and square section.
THA nail machines are suitable for production of following products: construction nail, lost-head joiner’s nail, flat-head joiner’s nail, nail for machine nailing, cartwright’s nail, moulder’s pin, lost-head square shank nail, angle-iron nail, lost-head nail, locksmith’s nail, upholstery tack, reed clasp pin, stub nail, wire dowel, shoemaker’s tack, bordered nail, U staple, U staple with oblique cut, al-alloy rivet, al-alloy nail (max. dia = 3d), knurled-shank nail, T-head nail, half-head nail, concrete nail, twisted nail, semiproduct of nail to be rolled (rolled helical nail for pallets, convex rolled nail for pallets).
Suitable wire diameter: from 0,71 mm to 4,2 mm.
(Always Remember: To prevent serious eye injury always wear safe eye protection when performing vehicle maintenance or service and follow recommended safety procedures.)
To adjust a wheel bearing on a trailer axle, first torque the inner adjusting nut to 200 ft. lbs. to seat the bearing rollers and the wheel seal. Always rotate the hub while torqueing the nut. Torque the adjusting nut to 200 ft. lbs. while rotating the hub. Then back the nut off one turn. Now, torque the nut to 50 ft. lbs. then back it off 1/4 turn. Install the retaining hardware and torque the jam nut to the proper specifications. For nuts less than 2 5/8″ 200-300 ft. lbs. and nuts greater than 2 5/8″ 300-400 ft. lbs, install the dial indicator and check in play. In play should be within 1 — 5000ths of an inch. If the in play is not within specs re-adjust the inner nut to obtain the correct in play.