ATF and Acetone tested on a rusty screw, bolt, see what the results were of the Test. This 50/50 mix is the most effective, inexpensive, cheapest penetrating oil you can make at home. A homebrew to break rusty bolts loose. I didn’t believe it until I did this test of Acetone and Automatic Transmission Fluid.
I’m sold, I will never go buy expensive penetrating oils again.
You can use this to break rust loose, free up spark plugs, for rust and it is also a great alternative to Kroil.
ChrisFix ATF ACETONE VIDEO:
https://youtu.be/2WuVBFTzoKc
Syyenergy7 ATF Acetone Test Video
https://youtu.be/KNbw8V8HZDY
Detailed Specific Numbers of Original Test:
https://www.mvcconline.org/catagory4/Home%20made%20penatrating%20oil.pdf
Don’t go out there and buy expensive oils, just use a 50/50 mix of Acetone (Lowes, Home Depot, Ace Hardware, etc.) and Automatic Transmission Fluid (ATF) It might take some time to break the bolt loose but it will come loose.
All Rights Reserved
Bundys Garage 2014
Copyright
Music By Randall Kent
Questions, Comments, Concerns:
bundysgarage@gmail.com
please subscribe
DISCLAIMER – DISCLAIMER – DISCLAIMER
Due to factors beyond the control of BundysGarage, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. BundysGarage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. BundysGarage recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of BundysGarage, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not BundysGarage.
I decided to make a couple of square head bolts for the clamp bolts on the stop instead of using commercial socket head cap screws. This video covers order of operations, working with multiple parts and turning and threading the shank. The next video will cover the work on the head, including cutting a radiused bottom groove, a large spherical radius on the ends and squaring the heads. I’ll also show how to heat treat the bolts to Rc60 to make them stronger and more durable.