In this video you will find out where a hidden adjustment screw is located on some carburetors.
Support me on Patreon;
https://patreon.com/donyboy73
Follow me on Facebook; https://www.facebook.com/pages/Donyboy73-The-Small-Engine-Doctor-on-Youtube/234040803408166
Twitter;
https://twitter.com/donyboy73
Instagram: https://instagram.com/donyboy73/
GOOGLE+ https://plus.google.com/u/0/b/101621394963699998790/101621394963699998790/posts?pageid=101621394963699998790
Due to factors beyond the control of DONYBOY73 “The Small Engine Doctor”, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. DONYBOY73 “The Small Engine Doctor” assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. DONYBOY73 “The Small Engine Doctor” recommends safe practices when working with power tools, hand tools, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of DONYBOY73 “The Small Engine Doctor”, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not DONYBOY73 “The Small Engine Doctor”.
#walbro #zama
Perhaps one of the least understood parts of installing an electric fan: Installing and wiring the controller. This Flex-a-lite controller turns the electric fan on and off according to the coolant temperature, and you can adjust where the fan turns on from approximately 180-240 degrees F. No relays are required if you use our controller with our electric fan. Wiring the controller is simple, and following our directions will give you years and years of trouble-free operation.