12 Years Factory wholesale ASTM A193 A320 B8 Threaded Stud Bolts for Bangkok Factory

ASTM A193 A320 B8 All Threaded Stud Bolts Standard: IFI-136, ASME B16.5, DIN976 Inch Size: 1/4”-4” with various lengths Metric Size: M6-M100 with various lengths Other Available Grade: ASTM A193/A193M B8 Class 1 & 2, B8M Class 1 & 2, ASTM A320/A320M B8 Class 1 & 2, B8M Class 1 & 2 Finish: Plain, PTFE etc. Packing: Bulk about 25 kgs each carton, 36 cartons each pallet Advantage: High Quality and Strict Quality Control, Competitive Price,Timely Delivery; Technical Support, Supply Test Reports Please feel free to contact us for more details.

  • 12 Years Factory wholesale ASTM A193 A320 B8 Threaded Stud Bolts for Bangkok Factory Related Video:



    Demonstration of my personally made suppressor designed to lower the amount of noise from firing my high powered rifles.



    Subscribe to our channel for the latest training videos, climbing tutorials and more! Unlike gym climbing, outdoor climbing typically requires an anchor to be created at the top of the route. There are several anchor systems to choose from. In this video, we review the “Sliding X.” This is an anchor which has gone in and out of style through the years, and has some pitfalls. It is not our most recommended anchor style, but we discuss it here so that you are familiar with if, how, and when to use it.

    The main benefit of the Sliding X is that it can automatically adjust the equalization point; therefore, it can be a good choice for a wandering climb, where the climber will traverse while climbing to the anchor.

    2 – Pre-existing bolts and hangers
    2 – Double-length slings
    2 – Non-locking carabiners
    AND
    1 – Locking carabiner -and- 1 non-locking carabiner
    OR
    2 – non locking carabiners
    OR
    2 – locking carabiners for the Master Point

    Step 1 – Clip the 2 non-locking carabiners into the bolted anchor points (one carabiner for each bolt hanger).

    Step 2 – Clip two double length slings (for redundancy) into each carabiner, and pull in the direction of the climber.

    Step 3 – Holding each “half” of the double length sling in one hand, which means you’ll have two strands in each hand, flip one to create a loop. This marks the X of the Sliding X.

    Step 4 – Clip all four strands with two opposite and opposed carabiners. The carabiners should slide smoothly from side to side as the slings adjust the equalization point.

    NOTE: At no point should the Master Point (which is less defined in this anchor, but is where the opposite and opposed carabiners rest) drop down and shock load either piece of the anchor. This is possible with the Sliding X if one of the bolts were to fail (and violates SRENE, see video). For this reason, we use two double length slings so we are very confident in the strength of the slings, and two unquestionably solid bolts.

    We hope you found this video helpful. Feel free to comment below with questions or thoughts!

    Please remember, climbing is inherently dangerous. Climb at your own risk. Visit https://ClimbingTechTips.com for related comments, additional videos, and community feedback!