Please find this product at https://absupply.net
This video is to bring you a closer look at the Bradley 9315 towel hook. A towel hook is generally an greater projection than robe hooks or coat hooks. Towel hooks are generally longer and this one indeed is. As you can also see the 9315 is in the bright polished finish and this is over stainless steel. There is a link below this video to the technical data drawing which is really nothing other than a link to the catalogue cut page, which shows the projection at 4-1/8 and we’re gonna get tape measure and verify that. So Bradley calls it out at 4-1/8 and that indeed looks correct. The assecution is 2″ by 2″, that’s not on the sheet but that’s a very typical standard for something like this, 2 by 2. Again solid stainless, it’s made of stainless steel, it’s all stainless. The method of mounting, here’s the backside of it and I have the wall clip removed. So, basically you take this wall clip with this faced to the wall, two screws are provided, like a number 8 by 1-1/2″ with a small roundhead on it. These two hooks will go out, once this is attached to the wall you’re robe hook basically there two hooks go inside and connect to the these two prongs that you see here. But once it’s hooked on there it stays in place. Securing it is done by this set screw that’s at the bottom, and that’s just a slotted set screw, you need a small screwdriver for doing so. Get it started by hand, and then when you tighten the set screw down don’t over tighten it. Once you tighten the set screw down it become quite solidly fixed to the wall at that point. You’re probably going to need some additional anchors if you’re going to drywall this obviously this would not be sufficient. But none the less they get you started with a couple of small little sheet metal screws. And that is the 9315 bright polished stainless finish. If you have any questions on the Bradley 9315 towel hook or any other Bradley product please do feel free to reach out to us. Thank you.
How to get to and replace your puking crank seal on tube frame Buells and Harley Sportster 1200 and 883′s. Main symptom: oil leaking out of your transmission vent tube.